Program Remote Key For 2014 Ford Mustang Via SKP-900
1. Connect SKP-900
Key Programmer to the car. And then turn on the
SKP-900 switch, it will enter into main menu, Click “
SYSTEM SELECTION” and choose “
IMMOBILIZER SYSTEM”
2. Insert the key into keyhole, and turn to the position “ON” (
Note: Do not crank the engine)
3. After selecting “
IMMOBILIZER SYSTEM”, it will pop out a new interface (shown below), just click “
Yes” to continue.
4. Next, it enters into “
FUNCTION SELECTION” interface and clicks “
DELETE KEY”, choose “
Yes” to proceed. And then appears a message about your current number of keys, click “
Yes” again to continue (
Note: Need about 10 minutes to finish programming).
5. Subsequently, It appears message shown at following picture, just insert the 1
st key and turn on the ignition.
6. You will find the light on (mark red).
7. Press “
Yes”, it comes out message as below.
8. Insert next key, the light come on and off for a while after turning the ignition on (it turns out to be normal).
9. Therefore, click “
NO” to exit. You can test the remote key whether is workable or not.