2014.11 BMW Rheingold ISTA-D 3.45.40 ISTA-P 53.5.003 Software HDD Technical Service


When install BMW ICOM A2 software or using BMW ICOM A2 to test models , you may meet a message to ask for "Update  your Firmware" 
Once getting this informations,pls dont worry 
Just download the firmware update file from following link and then update it is ok. 
https://mega.co.nz/#!T8B3xK7C!QeVVfQt3f8S9N03sHmWPyDtRnlFqn8DTBkQdv1c7148

But how to update it ?  The following is the detailed steps 

1. Connect ICOM A2 device with laptop via LAN cable, and then power on with 12V power adapter or connect with car model 
2.Open"http://169.254.33.45:60080/" with "Internet Explorer" browser.
Username and Password are "root/NZY1150263"
3.Click"Update Firmware", you will see all firmware informations.
4.Select"ICOM-BootImage-01-13-00.bin" file, set "image type" to "SYSTEM",click "Send the file"
5.When it comes with" Write the image file to the flash",Pls click"YES" and the LED will come to Red
6.When it shows"The SYSTEM IMAGE update was successfull",click"Update Firmware"
7.select"ICOM-ApplicationImage-01-18-00.bin", set"image type" to "APPLICATION",click"Send the file", but pls kindly noted it will take some minutes.
8.When it shows"Write the image file to the flash?", pls click"YES" and then LED will come to Red again.
9.After everything is back to normal,pls click"reboot" 

Kindly Note

1.Change "Local Area Connection" to automatic acquisition 
2.when updating, there are two file, first use small one and then the large one.
3.When use small one, you need to select" System" and the other is "APPLICATION"